Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Before you start...
Your safety and the safety of others are very important.
We have provided many important
safety message in this manual and
on your appliance. Always read
and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to
potential hazards that can killor
hurt you and others.
All safety messages will be preceded
by the safety alert symbol and the
word =DANGER" or WVARNING".
These words mean:
You can be killed or seriously
injured if you don't immediately
follow instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Check
location
where washer will be
installed, Proper installation
is your
responsibilily,
Make sure you have
everything
necessary
for correct
installation,
Do Not store or operate washer below
320F (0oC) (some water may remain in
washer).
Single washer
installations
require
12-inch (30 cm)
minimum
risers to
provide
an air
cushion
and
prevent
noise and
damage
to valves,
Grounded
electrical
outlet
is required,
See
Electrical
requirements,
Hot and cold water faucets: Must be
within 4 feet (1,2 m) of the back of
the washer and provide
water
pressure 10 -100 PSI (69-690 kPa), A
pressure reduction
valve should be
used in the supply line where
inlet
pressure entering
the building
exceeds
100 PSI (690 kPa) to prevent
damage
to the washer mixing valve,
Untape and
open washer
lid, Remove
packages
and
hoses from
washer,
Front access to the pump area is
available
by removing
2 clips under
the console
area and removing
the
fop and cabinet
assembly,
Important: Observe all governing
codes
and ordinances.
PAGE 2
Level floor: Maximum
slope
under washer-
1 inch (2,5 cm),
A floor drain should be
provided
under the bulkhead,
Prefabricated
bulkheads
with
electrical
outlets, water
supply
lines and drain facilities should
be used only where local
codes
permit,
Water heater: Set to
deliver
120°F (48,9°C)
water
to the washer,
Standpipe drain system: Needs a two-
inch (5 cm) minimum
carry-away
capacily
of 17 gallons
(64,4 liters) per
minute, Top of standpipe
must be at
least 39 inches (99 cm) high and no
higher than 72 inches (183 cm) from
bottom
of washer,
Suppod: Floor must be sturdy
enough
to support loaded
washer weight
of 315 pounds
(143 kg),
Tabla de contenido
