Electric Handle Heating; Starting / Stopping The Engine - Stihl MS 461 Manual De Instrucciones

English

Electric Handle Heating

Switching on the handle heating system
(depending on equipment version)
Set switch to F – to switch off, return
N
switch to the 0 position
Overheating during continuous use is
impossible. The heating system is
maintenance-free.
32
Starting / Stopping the
Engine
The four positions of the Master Control
lever
STOP
0
Stop 0 – engine off – ignition is switched
off
Run F – engine is running or can start
Warm start n – this position is for
starting the warm engine
Cold start l – this position is for starting
the cold engine
Adjusting the Master Control lever
The throttle trigger lockout and throttle
trigger must be pressed simultaneously
to adjust the Master Control lever from
run F to cold start l.
To set the Master Control lever to warm
start n, first set it to cold start l, then
push the Master Control lever into the
warm start n position.
Changing to warm start n is only
possible from the cold start l position.
When the throttle trigger is squeezed,
the Master Control lever returns from
warm start n to run F.
To switch off the engine, set the master
control lever to Stop 0.
Position cold start l
If the engine is cold
–
If the engine stalls during opening of
–
throttle after starting
If the fuel tank has run empty
–
(engine stalled out)
Position warm start n
If engine is warm (once the engine
–
has been running for approx. one
minute)
When the engine has turned over
–
for the first time
After ventilation of the combustion
–
chamber, if the engine was flooded
Holding the chain saw
There are two ways to hold the chain
saw during starting.
MS 461